Installing The Tumble Dryer - Miele PDR 914 Operating And Installation Instructions

Installation
48

Installing the tumble dryer

Place the tumble dryer on a perfectly level, secure, and horizontal

surface that is able to withstand the specified floor load.
The floor load created by the tumble dryer is concentrated and trans-
ferred to the installation surface via the screw feet. A base is not re-
quired. However, an uneven floor surface must be compensated for.
(19 11/16")
> 300
(> 11 13/16")
PDR 514/518/522/914/918/922
x 55 1/8" (1,400 mm)
y 35 11/16" (906 mm)
z PDR 514/914: 33 9/16" (852 mm)
PDR 518/918: 40 3/4" (1,035 mm)
PDR 522/922: 45 13/16" (1,164 mm)
To facilitate any future maintenance work, a maintenance corridor

with a width of at least 19 11/16" (500 mm) must be set up behind
the machine and must be accessible at all times. The distance be-
tween the machine and any walls must not fall below the specified
minimum values.
Adjust the tumble dryer screw feet until the machine is level. After

the machine has been aligned, screw the washers tightly to the base
plate using a screwdriver.
(24 13/16")
PDR 528/544/928/944
64 9/16" (1,640 mm)
47 1/2" (1,206 mm)
PDR 528/928: 40 1/16" (1,018 mm)
PDR 544/944: 54 1/2" (1,384 mm)