Table of Contents
Advertisement
1
Display Icons and Buttons
These are located behind the left hand door of the appliance.
Icon a
Icon b
Icon c
Icon d
Note - Icons a, b, c, d are only visible after pressing either buttons 1, 2, 3 or 4.
The appliance is designed for the storage of product at the appropriate temperature. It is not designed to chill product from a higher temperature.
Using the appliance in this manner may result in malfunction, damage and invalidate the warranty.
Standby
Pressing button 1 for 3 seconds will turn the unit on or into standby. When in standby the display will only display ' - ' . The remainder of the display will be blank.
When operating normally, the display will show the internal temperature of the cabinet.
Set Point
To display the appliance Set Point, with the display showing the temperature, press button 2 for 3 seconds and the display will show 'SP' . Then press button 1 once to
display the current set point.
Adjust the set point using button 2 to increase and button 4 to decrease. Press button 1 to save the new value and the display will show 'Loc' . If button 1 is not
pressed the new value will not be stored. Exit by pressing button 3.
If the Set Point cannot be adjusted to the value required please contact your authorised Foster dealer for advice.
The display will resume normal operation after 30 seconds or if button 3 is pressed.
EMD Multidecks - Service Manual
Operating Instructions
!
a
b
c
Icon g
Icon
a Compressor on / Alarm
b Evaporator fans on
c Defrost on
d 2nd operating function on
e °C / User menu active
Keypad locked / Service
f
function active
Decimal point / Defrost
g
active
Icon e
Button 2
º
C
Button 1
i
Button 3
Icon f
Button 4
Button
1
On / Off / Standby
2
Up / Increase value
3
Back / Exit
4
Down / Decrease value
5
Lights on/off
Button 5
5
Advertisement
Table of Contents
