Refrigerant Charge - Foster EMD700G Service Manual

Refrigerant Charge

The refrigerant charge weight can be found on the serial label within the appliance. Where this is not available please refer to the table below. The
information below is correct time of printing but is subject to change without prior notice.
EMD700
EMD900
EMD1200
EMD1500
EMD1800
Evaporator Fan Motors
The evaporator fan motors will continue to operate during defrost. This is normal and is required for the successful completion of the defrost
operation.
Defrost Indication
During defrost icon 4 will be illuminated. The controller display will be determined by the value set in parameter 'DDM' .
To start a defrost manually press and hold button 3 for 5 seconds. This will turn off the appliance. Continue to hold down button 3 after the
appliance has turned off. After a further 2 seconds the display will indicate a defrost has commenced (icon 4 illuminated) and the button can be
released. While the defrost function is operating the display will be determined by the value set in parameter DDM.
The defrost function will operate until either the time set in parameter DTO or the temperature set in parameter DLI is reached. Where parameter
TE is set to NO defrost will function on a time basis only. Upon completion of the defrost cycle the appliance will resume normal operation with
the current temperature displayed.
Note - On this appliance it is normal for the evaporator fans to continue to operate during a defrost cycle.
EMD Multidecks - Service Manual
111gms
130gms
119gms
147gms
138gms
15