Related Manuals for Foster EMD700G
Summary of Contents for Foster EMD700G
- Page 1 User Manual EMD Multidecks EMD700G, EMD900G, EMD1200G, EMD1200BLK, EMD1500G, EMD1800G.
- Page 2 Four Steps to extend the life of your appliance Getting to know your new Foster appliance Installation Using the appliance Maintenance www.fosterrefrigerator.com...
- Page 3 All installations must conform to local and municipal regulations and directives. In case of doubt contact your Foster authorised distributor or the Foster Technical Department. The information contained in this manual is current at the time of publication and is subject to change without notice.
-
Page 4: Climate Class
Climate Class Climate class indicated on the serial plate shows the ambient temperature & humidity at which this appli- ance has been tested, for the purposes of establishing values in line with European standards. Climate Class Temperature Relative humidity 25˚C Where the product is operated outside the design conditions above excess condensation may occur particularly on (though not limited to) the doors and end panels. -
Page 5: Disposal Requirements
Due to the weight of the appliance and that of the product contained within it the appliance may leave indentations in some types of floor coverings. The emitted sound level of this appliance is not greater than 70dB(A). To ensure stability the appliance should be located on a flat, level surface, correctly loaded. Do not use mechanical devices to accelerate the defrost process. -
Page 6: Installation
Installation Removal of packaging Prior to carrying out this operation please ensure that these instructions have been read, understood and that the necessary personnel and tools are available to ensure that these instructions are complied with. It is also recommended that a full assessment of the installation conditions and requirements be conducted prior to commencing this operation. - Page 7 Remove remainder of outer packaging. 4. Using at least 2 people remove the top packaging. Using the screwdriver remove the securing brackets from the rear of the appliance. EMD Multideck - User Manual...
- Page 8 Using the handles/spacers at the rear of the appliance carefully slide the appliance off the pallet onto the adjacent level surface. Note - Do not use the doors as a hand hold or pulling point. Note - The handles on the rear of the appliance also serve to maintain an adequate space to the rear of the appliance required for correct operation.
- Page 9 Start-Up and Test Sequence After unpacking, clean (cleaning directions supplied within this manual) and allow the appliance to stand for 60 minutes before turning on. Ensure the appliance is situated on a firm, level surface, away from both hot and cold air sources, as this will affect its performance.
-
Page 10: Using The Appliance
Using the appliance Display Icons and Buttons These are located behind the left hand door of the appliance. Icon e Button 2 Icon a º Button 1 Icon b Icon c Button 3 Icon d Icon g Icon f Button 4 Button 5 Icon Button... -
Page 11: Set Point
‘Loc’ . If button 1 is not pressed the new value will not be stored. Exit by pressing button 3. If the Set Point cannot be adjusted to the value required please contact your authorised Foster dealer for advice. -
Page 12: Keypad Sounds
These should be removed prior to use. Each shelf is capable of supporting the maximum weight of product listed below when evenly distributed.; Appliance Max weight per shelf EMD700G 50kg EMD900G 65kg EMD1200G 90kg EMD1500G 110kg... - Page 13 The shelf positions can be adjusted to suit specific requirements by following the procedure outlined below; Note - We recommend that at least 2 people carry out these instructions. Some items have been removed from the images to aid clarity. Lift the shelf clear of the shelf support brackets.
-
Page 14: Alarms Notification
Reconnect the shelf light and position the connector inside the shelf centre support. Lower the shelf into the new position ensuring that the shelf support brackets are fully engaged with the vertical support as shown above. Door Lock To lock the door insert the key and turn 90°, turn in the opposite direction to unlock. Alarms Notification If an alarm condition occurs the appliance will indicate this with an audible signal, by illuminating icon ‘a’... -
Page 15: Cleaning And Maintenance
6 to 12 months to maintain your warranty and ensure optimal performance of your appliance. We recommend that service is 6-12 MONTHS carried out by an authorised Foster agent or by contacting the Foster Service team using the contact details in this manual. EMD Multideck - User Manual... - Page 16 Cleaning Condenser Regular cleaning of the condenser (located behind the front cover) increases energy efficiency and prolongs the life of your appliance. Never use a wire brush, abrasive or corrosive materials to clean the condenser. This should be carried out periodically, by a competent engineer as outlined in the Regular Maintenance section of this manual.
-
Page 17: Troubleshooting
Service to arrange for this to be replaced. During this time the appliance cannot maintain an accurate temperature and all product should be removed and the appliance switched off. tE - This indicates that the evaporator probe has failed. Call your authorised dealer or Foster Service to arrange for this to be replaced. - Page 18 If the reason for the malfunction cannot be identified, disconnect the electrical supply from the appliance and contact your authorised dealer or Foster Service. When requesting a service call, please quote the model and serial number which can be found on the inside of the appliance on the right hand wall and begins with ‘E’...
- Page 19 Notes: EMD Multideck - User Manual...
- Page 20 By Appointment to Her Majesty Queen Elizabeth II Suppliers of Commercial Refrigeration Foster Refrigerator, King’s Lynn For more information: For service and spares: +44 (0) 1553 698485 For service +44 (0) 1553 780333 regional@foster-gamko.com service@foster-gamko.com fosterrefrigerator.com For parts +44 (0) 1553 780300 parts@foster-gamko.com...