Disposal Requirements; Electrical Safety - Foster EMD700G Service Manual

Disposal Requirements

This appliance contains components and materials (some of which are flammable) that may be harmful to the environment if
not disposed of correctly. Disposal of this appliance should be carried out by a suitably licenced waste contractor in accordance
with national laws and regulations which may be in force at the time. For more information please contact your local authority
environmental department.

Electrical Safety

This equipment shall be connected to an electrical supply protected by a Residual Current Device (RCD). This may
include a residual current circuit breaker (RCCB) type socket, or through a Residual Current Circuit Breaker with
overload protection (RCBO) supplied circuit.
Should it be necessary to replace the fuse, the replacement fuse must be of the value stated on the serial label for
the appliance.
Start-Up and Test Sequence
After unpacking, clean (cleaning directions supplied within this manual) and allow the appliance
to stand for 60 minutes before turning on.
Ensure the appliance is situated on a firm, level surface, away from both hot and cold air
sources, as this will affect its performance.
Place the appliance in a location so as not to exceed the maximum rated ambient
temperature.
The appliance produces warm air when operating normally and requires adequate
ventilation. The dimensions indicated are a minimum.
The air intake slot at the front of the appliance MUST be unobstructed across the full width
of the appliance.
Connect the appliance to a suitable power supply. Do not connect or disconnect the
appliance with wet hands. The appliance will turn on automatically displaying the actual
internal temperature of the appliance and 'PF' . To cancel the alarm press button 1. If this
does not happen and the display shows ' - ' press and hold button 1 for 3 seconds to
turn on the appliance.
As the operating temperature has been pre-set no adjustments are required. Allow the
appliance to reach its normal operating temperature before loading with product.
4
500mm
www.fosterrefrigerator.com