Related Manuals for Foster EcoPro G3 EP1/2H
Summary of Contents for Foster EcoPro G3 EP1/2H
- Page 1 User Manual Counters EP1/2H, EP1/2HRW, EP1/2M, EP1/2L EP1/3H, EP1/3HRW, EP1/3M, EP1/3L EP1/4H, EP1/4HRW, EP1/4M, EP2/2H, EP2/3H.
- Page 2 Four Steps to extend the life of your appliance Getting to know your new Foster appliance Installation Using the appliance Maintenance www.fosterrefrigerator.com...
- Page 3 All installations must conform to local and municipal regulations and directives. In case of doubt contact your Foster authorised distributor or the Foster Technical Department. The information contained in this manual is current at the time of publication and is subject to change without notice.
-
Page 4: Climate Class
Climate Class Climate class indicated on the serial plate shows the ambient temperature & humidity at which this appliance has been tested, for the purposes of establishing values in line with European standards. Climate Class Temperature Relative humidity 30˚C 40˚C General Safety Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance. -
Page 5: Electrical Safety
Electrical Safety Foster Refrigerator recommends that the equipment is electrically connected via a Residual Current Device (RCD); such as a Residual Current Circuit Breaker (RCCB) type socket, or through a Residual Current Circuit Breaker with Overload Protection (RCBO) supplied circuit. -
Page 6: Installation
Installation Removal of packaging Prior to carrying out this operation please ensure that these instructions have been read, understood and that the necessary personnel and tools are available to ensure that these instructions are complied with. It is also recommended that a full assessment of the installation conditions and requirements be conducted prior to commencing this operation. - Page 7 Position the pallet against a flat surface of a similar height to the pallet. Ensure that the castors and appliance door are locked. Support the appliance at the front and rear. Cut the support straps on both sides and unlock the castors.
- Page 8 Start-Up and Test Sequence After unpacking, clean (cleaning directions supplied within this manual) and allow the appliance to stand for 60 minutes before turning on. Ensure the appliance is situated on a firm, level surface, away from both hot and cold air sources, as this will affect its performance.
-
Page 9: Using The Appliance
Using the appliance Display Icons and Buttons Appliance internal Icon 5 temperature Icon 6 Button 1 Button 5 Icon 7 Button 3 Icon 8 Button 2 Button 4 Icon 1 Icon 4 Icon 2 Icon 3 Icon Button Compressor running Information menu Keypad locked Increase value... -
Page 10: Set Point
Adjust using button 2 and button 4. Press button 3 to save the new value. If button 3 is not pressed the new value will not be stored. If the Set Point cannot be adjusted to the value required please contact your authorised Foster dealer for advice. -
Page 11: Internal Light
Internal Light (Applicable to models with glass doors.) The light is operated using button 5. Press once to turn on the light and press again to turn off the light. Door Lock To lock the door insert the key and turn 90°, turn in the opposite direction to unlock. Keypad Security Settings We advise that this function is used to prevent unauthorised adjustment of the appliance and it’s operating temperature. -
Page 12: Cleaning And Maintenance
Maintenance Cleaning and Maintenance IMPORTANT: This appliance is heavy. When moving the appliance care should be taken and correct safe practices followed. Prior to cleaning ensure that the correct PPE is available and utilised and that the appliance is switched off and disconnected from the power supply. - Page 13 Cleaning Condenser Air Grill Use a soft brush or vacuum to remove loose dust and dirt from the Condenser Air Grill. Condenser Regular cleaning of the condenser (located behind the Condenser Air Grill) increases energy efficiency and prolongs the life of your appliance. Never use a wire brush, abrasive or corrosive materials to clean the condenser.
-
Page 14: Regular Maintenance
During this time the appliance cannot maintain an accurate temperature and all product should be removed and the appliance switched off. tE - This indicates that the evaporator probe has failed. Call your authorised dealer of Foster Service to arrange for this to be replaced. - Page 15 If the reason for the malfunction cannot be identified, disconnect the electrical supply from the appliance and contact your authorised dealer or Foster Service. When requesting a service call, please quote the model and serial number which can be found on the inside of the appliance on the right hand wall and begins with ‘E’ .
- Page 16 By Appointment to Her Majesty Queen Elizabeth II Suppliers of Commercial Refrigeration Foster Refrigerator, King’s Lynn For more information: For service and spares: +44 (0) 1553 698485 For service +44 (0) 1553 780333 regional@foster-gamko.com service@foster-gamko.com fosterrefrigerator.com For parts +44 (0) 1553 780300 parts@foster-gamko.com...