Input Se Ngs - Triax TMB 1700 User Manual

TMB 1700 programmable Amplifier

2.5 INPUT se ngs

DISPLAY READOUT
For op mal performance we recommend to only add single channels, unless you need to process a lot of channels.
EXPLANATION
Tap INPUT FM/V/U1 to enter the menu to configure input 1.
Use the arrows to navigate down in the submenu.
PRE-AMPLI: The internal amplifier is by default ON, only in
case of very strong incoming signals (if the strongest channel
on that input is higher than 80dBµV), it can be advised to
switch this OFF.
DC: Decide whether the input should provide power to an
external amplifier. Choose between OFF or 12 V.
Remark: If the external amplifier needs 24 V, you can change
this in advanced se ngs (see further).
Tap Add Channel to add channel.
First add the FM channel if applicable
Up to 6 channels can be added at once.
First select the star ng channel (e.g. CH5) and tap ENTER to
confirm. Then select the stop channel (e.g. CH7, this means
that you will add 3 channels). Tap ENTER to confirm. Then you
can convert them using the arrows bu on (e.g. CH5 to CH7
converts to CH8 to CH10) and tap ENTER to confirm.
Some other examples:
To add CH5 and convert to CH6,
select as follows: 5: 5  6: 6
To add CH21-22-23 and convert to CH31-32-33, select as
follows: 21:23
Remark 1: The value 85dBµV (in the bo om right corner)
indicates the incoming level of the channel.
Remark 2: For EU, Italy and New-Zealand region, Channel 13
(230-240MHz) can be used. CH13 cannot be converted.
Remark 3: A star () will appear when conver ng to a
different channel bandwidth: e.g. from a 7MHz channel to an
8 MHz channel
7
 31:33
EN