Installing The Sat If Input Distributor - Triax CGSD 162 Assembly Instruction Manual

4 i
n s t a l l i n g
Before installing or changing a module or accessory, switch off the head-
end station or unplug the power cable from the mains power socket.
Installing the SAT IF input distributor take care that no cables are squeezed
off or injured.
• Remove the front cover and the base plate of the CSE 2800 head-end sta-
tion.
• Insert the SAT IF input distributor
the LNB power connection
• Fasten the outer sockets of the SAT IF input distributor
lock washers put under each.
3
Tighten the nuts until the teeth on the lock washers have penetrated the exte-
rior coating and a good connection is made between the housing and the SAT
IF input distributor.
sat if
t h e i n p u t
A
2
d i s t r i b u t o r
above the output collector
1
is facing the control panel.
1 A
- 6 -
so that
2
with two nuts and
3
3
CGSD 162