Channel Scan - Triax TMB 1700 User Manual

2.4 CHANNEL scan

DISPLAY READOUT
EN
EXPLANATION
Use the arrows and validate with ENTER to enter the channel
scan menu
Scroll down to START and press ENTER to start scanning
Note: If you use an ac ve antenna or mast amplifier, ac vate
the DC before doing the Channel Scan (see next page: DC)
Scanning can take up to 1 minute
When scanning is finished, the number of detected channels
will be displayed. Manual changes can s ll be done a erwards
via the Input se ngs (next sec on)
Tap the ENTER bu on to proceed in the menu
Some mes, there can be transponders on the same frequency
coming from different antennas (e.g. CH40 is detected on
input 1 and input 2). These are called duplicate channels.
DUPLICATCH = When duplicate channels is ON, the weakest of
a pair of duplicate channels will be transferred to the LTE
band. The strongest of the pair keep its frequency at the
output.
When duplicate channels is OFF, the weakest of a pair of
duplicate channels will be rejected.
When REPOWER is ON, the device will do a rescan a er a
power interrup on of 6 seconds or less. If a power
interrup on takes longer than 6 seconds, channel se ngs will
not change.
When REPOWER is OFF, the device will never automa cally
rescan.
6
TMB 1700 programmable Amplifier