Output Se Ngs - Triax TMB 1700 User Manual

DISPLAY READOUT
To delete a (pair of) channel(s), posi on the arrow on the channel and press the ENTER bu on 3 seconds.
DISPLAY READOUT

2.6 OUTPUT se ngs

DISPLAY READOUT
Note: In the OUTPUT menu, you define the output level in dBµV of the MUX's. The TMB 1700 has enough gain to
guarantee this output level under all input condi ons.
EN
EXPLANATION
To add another (group of) channel(s), scroll down to ADD
CHANNEL and tap ENTER to confirm.
To prevent bad quality or scrambled images, make sure that
only one input channel is assigned to one output channel. If 2
channels are assigned to the same output channel, a star ()
will appear.
The same applies for adding mul ple channels. Make sure that
each output channel is selected only once.
EXPLANATION
To delete a (pair of) channel(s), posi on the arrow on the
channel and press the ENTER bu on 3 seconds.
When you have added all the channels to INPUT V/U 1, and
you want to add channels to the other inputs, scroll up to the
top of the menu (to INPUT V/U 1), tap the bu on ENTER and
scroll to the next input.
Repeat the previous steps for all input channels.
Define the OUTPUT LEVEL of the output signal.
Range between 88 dBµV and 108 dBµV (default output level
is 98 dBµV).
Note: The more channels you select, the less input power you
should give (e.g. 99 dBµV for 10 channels).
VHF ATTN: To compensate for cable losses, an a enuator of
up to 15 dB can be configured to decrease the VHF (up to
300MHz) output level (compared to the UHF output level
(above 300MHz).
8
TMB 1700 programmable Amplifier
EXPLANATION