Data General NOVA ECLIPSE 6234 Service Manual page 143

Data General Corporation (DGC) has prepared this manual for use by OGC personnel and customers as a guide to the proper installation, operation, and
maintenance of OGC equipment and software. The drawings and specifications contained herein are the property of OGC and
s~pll
neither
be
reproduced in
whole or in part without OGC's prior written approval nor be implied to grant any license to make, use, or sell equipment manufactured in accordance herewith .
• S.13
1.
POWER SWITCH REPLACEMENT (110-000359)
Power down the drive and unplug the line cord.
cover of the drive (see 5.2).
Remove the top
•
•
2. Locate the front panel power switch.
3. Pull one spade lug wire from the back of the switch and seat
it on the back of the new switch. Repeat this process until all
wires have been replaced (see Figure 5-22).
PIN
WIRE
COLOR
2 RED
3
ORANGE
5 YELLOW
6
GREEN
8
BLUE
9
VIOLET
FS-03448
Figure 5-22.
Power Switch Wire Connections
4. Remove the two switch mounting screws retaining the switch being
replaced.
5. Seat the new switch and fasten into place with the screws removed
in step 4.
6. Replace the top cover (see 5.2) and plug in the line cord •
015-000133
5-25