Data General NOVA ECLIPSE 6234 Service Manual page 117

•
•
•
Data General Corporation (DGC) has prepared this manual for use by OGC personnel and customers as a guide to the proper installation, operation, and
maintenance of OGC equipment and software. The drawings and specifications contained herein are the property of OGC and shall neither be reproduced in
whole or in part without DGC's prior written approval nor be implied to grant any license to make, use. or sell equipment manufactured1n accordance herewith.
Additional commands to open cell are:
"ADR"/
./
.+"ADR"/
.-"ADR"/
"CR"
"LF"
I
+"ADR"/
-"ADR"/
Open cell and print its contents
Open the cell currently pointed to by the pointer
and print its contents
Add "ADR" to the pointer, open the cell and print
its contents
Subtract "ADR" from the pointer, open the cell and
print its contents
The return key is used to close the open cell with
or without modification
Line feed is used to close the open cell with or
without modification and to open the succeeding cell
Close the open cell with or without modification and
open the preceeding cell
Close the open cell without modification, and open
the cell pointed to by its contents
Close the open cell without modification, and open
the cell pointed to by its contents - "ADR" •
Close the open cell without modification, and open
the cell pointed to by its contents - "ADR".
Cell Modification - Once a cell has been opened its contents can be
modified by typing the new value the cell is to contain in the form of
an octal expression followed by "CR" or "LF". If a + or - is typed as
the first character of the expression then the value of the expression
is added to or subtracted from the contents of the cell. The address
itself or an expression relative to the address can be deposited by
typing a"." or" .+/-octal expression". A rubout command given right
after opening a cell allows the modification of its contents as if they
were typed in just before the command was issued.
Other ODT Commands -
RUBOUT
"ADR"B
This key is used to delete erroneously typed digits.
Each time the key is pressed the right most digit
is deleted and echoed on the terminal. If the
rubout key is pressed right after opening a cell,
then it deletes the right most digit of the cell's
contents. This allows the modification of the cell
as if its contents were typed in just before the key
was depressed.
Insert a break point at location "ADR". Only one
break point can be inserted and any entry to ODT
after executing a break point will cause it to be
deleted.
015-000133
4-73