Memory Structure - Yamaha GW10 Owner's Manual

Memory Structure

10
The 20 effect programs of the GW10 are organized in four banks, each with five
programs.
Bank 1
Program 5
Program 4
Program 3
Program 2
Program 1
To select an effect program:
1
Make sure that the GW10 is in normal operation. (In other words, make
sure that the Tuner function or the Write/Copy/Swap operations are not
active.) To return to normal operation, press the B(NO) button or
simply turn the power off and on again. In this condition, some LEDs will
be lit, but none will be flashing.
NOTE Alternatively, you can exit the Tuner function by pressing the
M Pedal Switch or the Foot Controller.
2
Advance through the various effect programs by pressing the
M Pedal Switch or the T(YES) button.
Each press of either of these advances to the next effect program.
The selected effect program number appears in the MEMORY/TUNER
indicator and the bank number is indicated by the BANK LEDs.
Shows the current
bank number
The four banks are indicated by the LEDs as shown below. (For instruc-
tions on how to select different banks, see step #3 below.)
Bank 1
BANK
both LEDs off
Bank 2 Bank 3
Program 5 Program 5
Program 4 Program 4
Program 3 Program 3
Program 2 Program 2
Program 1 Program 1
BLOCK
NO
WRITE
A=44
Hz
BANK
MEMORY / TUNER
Bank 2 Bank 3
BANK BANK
green LED lit red LED lit
Bank 4
Program 5
Program 4
Program 3
Program 2
Program 1
TYPE
YES
Shows the current effect
program number
Bank 4
BANK
both LEDs lit