Using The Foot Controller To Turn Effect Blocks On And Off; Assigning Effect Block On/Off Groups; Changing The Effect Type - Yamaha GW10 Owner's Manual

Using the Foot Controller to Turn Effect Blocks On and Off

The Foot Controller can be used to instantly turn
pre-assigned effect blocks on and off. The green
ON OFF GROUP LEDs above the Effect Block
buttons indicate which effect blocks are assigned
for this. For example, if the green LEDs above
H and L are lit, the Chorus and Delay
blocks can be turned on or off with the Foot
Controller. (For instructions on how to set the
on/off group, see "Assigning Effect Block On/
Off Groups" below.)

Assigning Effect Block On/Off Groups

OPERATION
To set which effect blocks are to be turned on
and off with the Foot Controller, press and hold
the appropriate Effect Block button(s) (D,
H, or L) corresponding to the effect block
or blocks you wish to turn on or off. Hold the
button or buttons for about one second, or until
the green LEDs above the selected Effect Block
buttons light.
OPERATION
1
Press B repeatedly until the desired
block is selected. (One of the effect type
LEDs in the block will flash.)
2
Press T repeatedly until the desired
effect type is selected. (The selected effect
type LED in the block will flash.)
OPERATION
Push the Foot Controller down to its maximum
setting, then firmly press it once. The selected
effect block or blocks (along with their LEDs)
will appropriately turn on or off.
NOTE
be lit in normal operation, meaning that at least
one block will always be assigned for on/off
control with the Foot Controller. However, you
can disable this on/off switching entirely; see
DISABLING THE EFFECT ON/OFF SWITCHING
OF THE FOOT CONTROLLER, page 35.

CHANGING THE EFFECT TYPE

3
Write (save) the new setting to memory, if
desired. (See SAVING AN EFFECT
PROGRAM on page 37 for details.)
At least one of these LEDs will always
25
Reference