Yamaha GW10 Owner's Manual page 10

6
u VOLUME POSITION Indicators
When the Foot Controller is used as a volume pedal, one of these lights to
indicate the position of the volume pedal in the effect chain. (See page 33.)
i Effect Type Indicators
These light to indicate the selected effect type in the effect block (or the
selected parameter category in the Foot Controller block, indicated by the
Foot Controller symbol). Only one of these in each block can be selected
at a time. (See pages 21, 25, 26.) When one of these indicators flashes,
the respective parameters can be edited. (See pages 20, 26.)
o Parameter Dials
For adjusting the three parameters of a selected effect. The parameters in a
single column correspond to the dial in that column.
!0 BLOCK / WRITE NO Button
This button serves several purposes:
• In normal operation, this is used to select effect blocks for editing.
(See pages 20, 25, 26.)
• When this is held down for a couple of seconds (until all LEDs go
out), it calls up the Tuner operation. Pressing it during the Tuner
operation returns to normal operation. (See page 41.)
• When this is held down and the T button is pressed, it calls up
the Write, Copy, and Swap operations. (See pages 37–39.)
• During Write, Copy, and Swap operations, this is used to cancel the
respective operation. (See pages 37–39.)
!1 TYPE / WRITE YES Button
This button serves several purposes:
• In normal operation, this is used to select effect types for editing.
(See pages 21, 25, 26.)
• Also, in normal operation (when no LEDs are flashing), this is used to
advance through the effect program numbers. (See pages 10, 11, 24.)
• In Tuner operation, this is used to adjust the tuning standard for the
note A above middle C (from 440 to 445). (See page 41.)
• When this is pressed while the B button is held down, it calls
up the Write, Copy, and Swap operations. (See pages 37–39.)
• During Write, Copy, and Swap operations, this is used to execute the
respective operation. (See pages 37–39.)
!2 MEMORY/BANK Pedal Switch
• In normal operation and in Write, Copy, and Swap operations,
pressing this steps through the effect program numbers. Holding the
switch down advances through the bank numbers. (See pages 10, 24.)
• During Tuner operation, pressing this returns to normal operation.
(See page 41.)
!3 Foot Controller
For continuous control over volume or a selected effect parameter. When
pressed firmly beyond the maximum, this turns selected effect blocks on or
off. (See pages 19, 25.) Pressing this firmly beyond the maximum and
holding it down for a couple of seconds (until all LEDs go out) calls up the
Tuner operation. (See page 41.)