Card Guide Adjustment; Left Margin Home Position Check - Wang DW/OS-20 Maintenance Manual

•
•
•
3305
10. Insert paper •
11. Select Printer.
12. Print two lines, at least.
13. Check that the printing is horizontally aligned with the horizontal
segment of the card guide as shown in figure 5-18. Either the
roll-up or the roll-down switch may be used to J'O&ition the line of
characters.
14. If alignment is incorrect, adjust as described below.
5.2.1.1.17 Card Guide Adjustment
1.
Loosen the two card-guide mounting screws (see figure 5-18).
2. Move card guide so that the horizontal segment of the card guide is
parallel to the previously printed material.
3. Hold guide stationary and tighten screws.
5.2.1.1.18 Left Margin Home Position Check
1. Turn power on and load OS software •
2.
Remove OS software diskette (on single-disk system), and load
document (archive) disk.
3. Select Print Document on menu.
4. Name document.
5. Execute,
6. Select printing parameters, left margin at 00.
7. Execute.
8. Insert paper and Select Printer.
9. Print several lines.
10.
Check that the left-margin home position is 0.55 .:!:. 0.016 inch (1.4+
0.0. cm) from the left side of the paper when the margin is set at 00
on the print menu •
5-23