Troubleshooting
This chapter explains the following:
•
•
•
•
Locating LEDs and Components
The panel layouts for this appliance are described in:
•
•
Definitions of LED States
The various LED states are defined in the
Reset from the Internal Recovery Partition (IRP)
The Cisco Expressway CE1300 appliance comes pre-installed with an M.2 device that you can use to reinstall
of your appliance to factory state.
Before you begin
You need to set up and access the CIMC, as described in
Task: IRP Reinstall Using the KVM Console
Step 1
Launch the KVM Console using the icon in the CIMC.
Step 2
Power up the CE1300 and, when prompted, press
Locating LEDs and Components, on page 29
Definitions of LED States, on page 29
Reset from the Internal Recovery Partition (IRP), on page 29
Lag During Boot up Due to Power Characterization Check, on page 30
Front Panel Layout
Rear Panel Layout
A P P E N D I X
Cisco UCS C220 M6S Server Installation and Service
Run the Install
to enter the
.
F6
boot menu
Cisco Expressway CE1300 Appliance Installation Guide (X14.3.1)
B
Guide.
Wizard.
29