Run The Install Wizard; Install Wizard Process - Cisco Expressway CE1300 Installation Manual

Run the Install Wizard

After the system boots up the terminal emulator program on the PC displays Cisco Expressway startup
information. After approximately four minutes the Install Wizard is displayed.
If the Cisco Expressway was already on when you connected and you do not see the Install Wizard, press
Ctrl+D
Ctrl+D
This chapter explains the following:
•

Install Wizard Process

1. Follow the prompts in the Install Wizard to specify the following:
If you plan to deploy the appliance as an Expressway-E then you must enable the web UI. It's not possible
to configure the appliance as an Expressway-E through the CLI.
2. Wait for the wizard to finish and the Installation wizard complete message to appear.
3. Press Enter to continue.
4. The system applies the specified settings and continues to boot.
5. After the boot completes, the Expressway is ready to use.
to access it. If you encounter issues or enter incorrect information during the wizard, you can press
to restart it.
Install Wizard Process, on page 23
• IPv4, IPv6, or both.
• LAN 1 IPv4 subnet mask of the Cisco Expressway (if you select IPv4).
• IP address of the Expressway default gateway.
• Password for root user account.
• Password for admin user account.
• Whether to enable the Expressway web UI (recommended).
• Whether to allow SSH access to the Cisco Expressway CLI.
• Timezone. The default is UTC. You can search and replace with your desired zone in the wizard. Or
you can change it later through the System > Time page in the web user interface.
C H A P T E R
Cisco Expressway CE1300 Appliance Installation Guide (X14.3.1)
8
23