Table of Contents
Advertisement
Declaration of Conformity
Manufactured by:
Finish Thompson, Inc.
921 Greengarden Road
Erie, Pennsylvania 16501 U.S.A.
Phone: 1-(814)-455-4478
Fax
1-(814)-455-8518
Email:
fti@finishthompson.com
Web:
www.finishthompson.com
FTZU 06 ATEX A136-06
Finish Thompson declares under our sole responsibility that the product listed below conforms to the relevant provisions
of 2014/34/EU for equipment and protective systems intended for use in potentially explosive atmospheres, and is
certified for safe use in Group II category 2 areas.
This declaration applies to Finish Thompson, Inc ATEX DB Series pumps only manufactured out of carbon fiber filled
PVDF with a conductive motor adapter and non-sparking ring designated by the letter "V" and "A" in the model number.
Pumps and their model number may also contain many different combinations of bushings, shafts, O-rings, port
connections, impellers, magnet sets, motor adapters and other options.
Models: DB22V-A.
This product has used the following designated standards to verify conformance:
Non-electrical equipment for potentially explosive atmospheres: EN ISO 80079-36:2016
Basic Methods and Requirements.
Non-electrical equipment intended for use in potentially explosive atmospheres: EN ISO 80079-37
Protection by construction safety "ch" and control of ignition source "bh".
This product must not be used in areas other than specified above. If in doubt consult an authorized
Approved by:
distributor, or refer to the manufacturer Finish Thompson.
II 2GD
Ex h IIC T6...T4 Gb
Ex h IIIC T6...T4 Db
FTZU 08 ATEX A174-08
FTZU 07 ATEX A166-07
3
1026
Date: 06/01/2023
Advertisement
Table of Contents
