Yamaha A3000 Upgrade Manual page 33

EDIT - MIDI/CTRL - SmpCtl1 [Sample Controller Setup 1]
• Knob 3 offers three additional devices: Note Number, Velocity, and Program LFO.
• The program LFO is a new feature on Version 2. To set the program LFO to modify a
• On Version 1, the Device indication showed only the controller number. On Version 2,
• Knobs 4 and 5 include three new parameters: FEG Level (filter-EG level), CutoffDistanc
EDIT - MIDI/CTRL - SmpCtl2 [Sample Controller Setup 2]
The Knob 3 control type offers two new settings, +ofst(-exp) and -ofst(+exp). Like the
+offset setting, these two new settings will also cause the A3000 to convert received
control-change value to a corresponding value in the range {0 to Range}. The difference
is that +offset uses a linear conversion, +ofst(-exp) produces exponentially greater changes
at lower control-change values, -and ofst(+exp) produces greater changes at higher val-
ues.
specific controller, just set Knob 3 to Program LFO and then turn Knob 4 or Knob 5 to
select the parameter. (The program LFO itself is set up at the PLAY | CONTROL
PgmLF01 and PgmLF02 pages.)
it shows both the controller number and the corresponding device (if any). If you have
set up a knob to act as controller, then the knob name and transmit channel will both
appear next to the controller number (for example, 073/K4( 5) would indicate that
Knob 4 is set to operate as Controller 073 transmitting over Transmit Channel 5).
(distance between filter frequencies), and Filter Gain.
Changes in EDIT MODE
210
213
Chapter 2 Upgrade Reference
33