Yamaha A3000 Upgrade Manual page 27

PLAY - CONTROL - PgmLFO2
• Knob 2 sets the LFO's initial phase. If Sync = MIDI, this phase will coincide with the
• Knob 3 sets the MIDI channel that can be used to reset the LFO. You can set the value
• Knob 4 sets the specific note that generates the reset. This setting is available only if
• It is recommended that you use the note you select here only as a "reset switch," and
start of the MIDI-clocked note length. If Sync = manual, this phase is produced by
LFO reset. Note that reset conditions themselves are set up by Knobs 3 and 4 as
follows.
to off (resets disabled); audition (reset generated by pressing the AUDITION key); 1 to
16 (reset generated by note-on events over the specified MIDI channel only), or Bch
(reset generated by note-on events received over the basic receive channel).
Knob 3 is set to 1 to 16 or to Bch. You can select any single note on the keyboard (C-
2 to G8), or you can select all notes. Reset is generated when a note-on event for the
specified note is received over the MIDI channel selected by Knob 3.
that you avoid mapping any samples to it. Although it is possible to use this note both
for reset and playback purposes, the playback timing may be noticeably delayed.
[Program-LFO Setup 2]
Chapter 2
Changes in PLAY MODE
Upgrade Reference
27