Yamaha A3000 Upgrade Manual page 32

Changes in EDIT MODE
EDIT - FILTER - Filter
EDIT - FILTER - FltSens
Chapter 2 Upgrade Reference
32
Version 2 includes the following additional filter types (Knob-2 Type settings).
LowPass3
Low pass filter #3
Peak1
Emphasis at a specified frequency
Peak2
Emphasis at specified frequency
2Peaks
Emphasis at two specified frequencies
2Dips
De-emphasis at two specified frequencies
DualLPFs
Two low-pass filters
LPF+Peak
Low-pass filter combined with peak filter
DualHPFs
Two high-pass filters
HPF+Peak
High-pass filter combined with peak filter
LPF+HPF
Low-pass filter combined with high-pass filter
Note that if you select any of the final seven filters in the above listing, you will need to
set two frequencies. Use Knob 3 (Cutoff) to set the first of the frequencies; and then use
the new Distance parameter (at Knob 4) to set the second frequency by its (positive or
negative) distance from the first. Note that a 0 distance setting will cause the frequen-
cies to coincide. (For the LPF+Peak, HPF+Peak, and LPF+HPF frequencies, the Cutoff
value sets the frequency for the filter written at the left side, and the Distance setting
determines the frequency for the filter written at the right side.)
On Version 1, Knob 4 controlled the FltGain parameter. On Version 2, this parameter is
now located at Knob 5 in the FltSens page.
[Filter Sensitivity]
• Five new "random" settings, Rnd1 to Rnd5, have been added to the Vel
Vel Q/Width parameters at Knobs 2 and 4. You can select these settings by turn-
ing the knob to the right (so that it moves past +63). Each of values causes the
corresponding characteristic (frequency or Q/Width) to vary at random around its
true setting each time a note is played, where Rnd1 produces the smallest amount of
variation and Rnd5 produces the greatest.
• It is no longer possible to use Knob 3 to set the Vel
Knob 5 to set the Vel Q/Width parameter.
• Knob 5 now sets the FltGain (filter gain) parameter. On Version 1 this parameter was
located in the Filter page (see page 182 of the Owner's Manual).
182
184
Cutoff and
Cutoff parameter, or to use