Screw In Valve In Pipe (Threaded Connection); Install Valve On Base Block (Flange Connection) - Burkert 2871 Operating Instructions Manual

Type 2871
Installation
7.3

Screw in valve in pipe (threaded connection)

NOTE!
▶ Use an open-end wrench for installation.
▶ Do not use the coil as a lever arm.
→ Hold the proportional valve with an open-end wrench on the valve body.
→ Screw into pipe.
→ Check installation for tightness.
7.4

Install valve on base block (flange connection)

→ Fasten the valve to the base block using both fastening screws.
Tightening torque 0.8...1.2 Nm.
English
13