For Your Safety - Fein KBE 35 Manual

OBJ_BUCH-0000000212-001.book Page 25 Thursday, July 23, 2015 3:49 PM
Character Unit of measure-
ment, international
P
W
1
P W
2
n
/min, min
0R
r/min
in
inch
U
V
f
Hz
M... mm
Ø mm
mm
Fe HM
mm
Fe HSS
mm
mm
mm
mm
kg
L
dB
pA
L
dB
wA
L
dB
pCpeak
K...
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s

For your safety.

Read all safety warnings and all
WARNING
instructions. Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have thor-
oughly read and completely understood this
Instruction Manual and the enclosed "General
Safety Instructions" (document number
3 41 30 054 06 1). The documents mentioned should be
kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial safety
regulations.
Intended use of the power tool:
Magnetic core drill unit for drilling with core drill bits and
solid drill bits and countersinking on materials with sur-
faces suitable for magnets in weather-protected environ-
ments using the application tools and accessories
recommended by FEIN.
This power tool is also suitable for use with AC genera-
tors with sufficient power output that correspond to the
Standard ISO 8528, design type G2. This Standard is par-
ticularly not complied with when the so-called distortion
factor exceeds 10 %. When in doubt, please refer to the
generator instruction/specification guide.
Unit of measure-
ment, national
W
W
-1
, rpm, rpm
inch
V
Hz
mm
mm
mm
mm
mm
mm
mm
mm
kg
dB
dB
dB
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2 2
min, m/s
These appliances are not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
Special safety instructions.
Wear personal protective equipment. Depending on the
application, use a face shield, safety goggles or safety
glasses. Wear ear protection. The safety glasses must be
capable of protecting against flying particles generated by
the various different operations. Prolonged exposure to
high intensity noise may cause loss of hearing.
Do not touch the sharp edges of the core drill bit. Danger
of injury.
Replace the protective cable bushing immediately when
damaged. A defective protective cable bushing can lead
to overheating of the machine and to an emergency stop.
Always secure the power tool with with the supplied lash-
ing strap. In case of a power failure or when the mains
plug is pulled, the magnetic holding power is not main-
tained. When carrying out such work, beware of falling
objects, such as cores or chips.
Explanation
Power input
Output
No-load speed (clockwise)
Size
Rated voltage
Frequency
Size of metric thread
Diameter of a round part
Drilling capacity in steel - TCT (core drill bit)
Drilling capacity in steel - high speed steel (HSS)
(core drill bit)
Drilling capacity in steel - high speed steel (HSS)
(twist drill bit)
Max. drill chuck capacity
Reamer diameter
Counterboring diameter
Weight according to EPTA-Procedure 01
Sound pressure level
Sound power level
Peak sound pressure level
Uncertainty
Basic and derived units of measurement from the
international system of units SI.
en
25