Inserting The Bobbin; Changing The Presser Foot - Husqvarna VIKING Designer RUBY 90 User Manual

Note: If you experience difficulty winding a bobbin through the needle
and you are using a large thread cone, move the cone to the auxiliary
spool pin and use the right clip on the telescopic thread guide instead.
Place the large spool holder with the flat side up and a cone holder on
the auxiliary spool pin before adding the thread cone.

Inserting the Bobbin

Use only the bobbins designed for your DESIGNER
RUBY™ 90 machine.
1. Open the bobbin cover by pushing the release button (A)
to the right. Remove the cover.
2. Place the bobbin in the bobbin case. It drops in only one
way with the logo facing up. The bobbin will then rotate
counterclockwise when you pull the thread.
3. Place your finger on the bobbin to keep it from turning
as you pull the thread firmly to the right and then to the
left into the tension spring (B) until it "clicks" into place.
Continue threading around (C) and to the right of the
thread cutter (D).
4. Replace the bobbin cover. Pull the thread to the left to
cut.

Changing the Presser Foot

1. Make sure that the needle is in the highest position. Pull
the presser foot down and towards you.
2. Line up the cross pin on the foot with the gap in the
presser foot ankle. Push the foot into the gap until the
foot snaps into place.
2 Preparations 47