Winding The Bobbin Using The Auxiliary Spool Pin; Inserting The Bobbin - Husqvarna Viking Tribute 150C User Manual

WINDING THE BOBBIN USING
THE AUXILIARY SPOOL PIN
1. Place an empty bobbin on the bobbin spindle on the top
of the machine. The bobbin only fits on one way, with
the logo facing up. Use only original HUSQVARNA
VIKING bobbins.
®
2. Fold out the auxiliary spool pin. Place a spool cap and a
felt pad under the spool.
3. Bring the thread over and behind the pre-tension thread
guide (A) and down around the thread tension disc (B),
then through thread guide (C) as illustrated.
4. Guide the thread through the hole in the bobbin (D) from
the inside to the outside.
5. Push the bobbin spindle to the right. A pop-up message
appears on the GraphicDisplay. Hold the end of the thread
firmly when starting to wind. Press the foot control to start
winding. Once the bobbin begins to wind, cut the excess
thread. When the bobbin is full it will stop rotating. Push
the bobbin spindle back to the left, remove the bobbin and
cut off the thread on the thread cutter.

INSERTING THE BOBBIN

Press the ON/OFF switch to OFF.
1. Remove the bobbin cover by sliding it towards you.
2. Place the bobbin in the bobbin case. It drops in only one
way with the logo facing up. The thread unreels from the
left of the bobbin. The bobbin will then rotate counter-
clockwise when you pull the thread.
3. Place your finger on the bobbin to keep it from turning as
you pull the thread firmly to the right and then to the left
into the tension spring (E) until it "clicks" into place.
4. Continue threading around (F) and to the right of the
thread cutter (G). Slide on the bobbin cover (H). Pull the
thread to the left to cut (I).
20 – Getting Ready to Sew
A
B
1.
F
E
G
3.
D
C
2.
I
H
4.