Automatic Thread Cutter; Automatic Fix; Stitch Limiting Options - Husqvarna VIKING Designer RUBY 90 User Manual

Automatic Thread Cutter

When selected, the threads are cut automatically in the
following situations:
• At cut commands in stitches and programs.
• After sewing a single stitch e.g. a monogram or eyelets.
If deselected, no automatic thread cut will be performed.
Note: Deselect when using optional accessories that are attached in the
two holes in the needle plate just above the bobbin cover, to prevent
damage to the automatic thread cutter knife located under the needle
plate.

Automatic FIX

When selected, the machine will automatically activate the
FIX function after a cut has been performed and when a
stitch is selected.

Stitch Limiting Options

Set the machine to either stitch width safety or select the size
of the twin needle to limit the stitch width and stitch
positioning. This will minimize the risk of breaking a needle
when sewing with accessories that do not allow the use of the
enire stitch width.
Stitch Width Safety
When selected, the machine will only allow a centered
straight stitch to prevent damage to the needle, presser foot
and needle plate. Select stitch width safety when using an
accessory that only supports a centered needle position e.g.
straight stitch presser foot. Stitch width safety will
automatically be selected when the Straight Stitch Plate is
attached to the machine and cannot be deselected as long as
the Straight Stitch Plate is attached.
When the Straight Stitch Plate is removed you will be given
the option to keep stitch width safety selected or to deselect
it. When stitch width safety is activated all twin needle sizes
will be disabled as they cannot be used together with stitch
width safety.
Note: The settings are reset at the start of a new project from the
JoyOS ADVISOR™ feature. Always make sure to remove any
accessory that requires this setting or select the setting again after starting
a new project.
11 Settings 155