Unpacking Machine And Embroidery Unit; Connect The Power Cord And Foot Control - Husqvarna VIKING Designer RUBY 90 User Manual

Unpacking Machine and Embroidery
Unit
After lifting the machine out of the box and removing all
packing material and the plastic bag, wipe the machine,
particularly around the needle and needle plate to remove any
oil before sewing.
When unpacking the embroidery unit, do not throw away the
black styrofoam inside the embroidery unit carrying bag, as
this is designed for storing the embroidery unit when not in
use.
Note: The machine is delivered with a red safety catch attached to the
presser foot bar. Remove the safety catch before sewing.
Note: Your DESIGNER RUBY™ 90 machine is adjusted to
provide the best stitch result at normal room temperature. Extreme hot
and cold temperatures can affect the sewn result.
Connect the Power Cord and Foot
Control
Among the accessories you will find the power cord and the
foot control.
Note: Before plugging in the foot control, check to ensure that it is type
"FR5" (see underside of foot control).
• Pull out the cord from the foot control. Connect the foot
control cord to the socket (1) on the bottom right side of
the machine.
• Connect the power cord to the rear socket (2) on the
bottom right side of the machine. Plug the cord into the
wall socket.
• Press the ON/OFF switch (3) to "I" to turn on power
and light.
For the USA and Canada
This sewing machine has a polarized plug (one blade wider
than the other). To reduce the risk of electric shock, this
plug is intended to fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified electrician to install
the proper outlet. Do not modify the plug in any way.
30 2 Preparations