Design Positioning Wizard - Husqvarna VIKING Designer RUBY 90 User Manual

Design Positioning Wizard

1. To Select a Locking Point on Screen
Touch number 1 to select a locking point. Move the blue
cursor with your finger to the point in the design on your
screen that you want to match to a point on your fabric/
previously stitched design. Fine tune with the arrows in the
control wheel. If you want to place the locking point in a
corner or center of the design, open set cursor point options
and use set cursor point buttons. Touch the zoom options
button and use the zoom to cursor to maximize the zoom
and pan the embroidery area for exact position of the cursor.
2. Move Locked Point on Fabric
Touch number 2. The blue cursor will be locked to the design.
It will change color from blue to red with a ring around the
center of the locking point. Touch and move with your finger
on the screen to position your design exactly where you want
it to match on the fabric or to the previously stitched design.
Use the arrows in the control wheel to fine tune. Watch the
hoop until the needle is exactly where you want it to be on
the fabric or the previously stitched design. The locking
point on the fabric shows the position of the needle in the
design.
Note: If satisfied with the placement of your design, touch OK to close
design positioning. If you also need to adjust the angle of the design,
continue with step 3.
3. Set Matching Point on Screen
Touch number 3 to select another matching point on the
design to match a second position on the fabric or previously
stitched design.
Touch and move the blue cursor on the screen to where you
would like the matching point to be in your design. Fine tune
with the arrows in the control wheel. Use the zoom to cursor
button to maximize the zoom and pan the embroidery area
for exact position of the cursor.
136 9 Embroidery Stitch Out