Setting Between Thread Take-Up And Upper / Lower Thread Guide - Husqvarna VIKING HUSKYLOCK 936 Service Manual

22. SETTING BETWEEN THREAD TAKE-UP AND UPPER / LOWER
THREAD GUIDE
Front cover must be mounted
CHECK
When the upper looper is in its lowest position the distance between
the upper looper thread guide (D) and...
the upperlooper thread take-up (B) should be
the lower looper thread take-up (C) should be
ADJUSTMENT
1. Move the upper looper to its lowest position
by turning the handwheel towards you.
2. Loosen the screw (A).
3. Adjust the distance between the thread guide (D)
and the upper looper thread take-up (B) so
it's 35.2 mm.
4. Adjust the distance between the thread guide (D)
and the lower looper thread take-up (C) so
it's 61.7 mm.
5. Tighten the screw (A).
NOTE ! Both upper and lower thread take-up is adjusted at the same time.
26 Husqvarna Viking Huskylock 936 104 72 49-26