Installation - Bootstrap Farmer DIY High Tunnel Plans Instructions Manual

Installation

1. Install spring wire starting at the middle top of the hoop down to the hip board.
2. Spring wire from the top down on the other side of the hoop.
3. On the opposite end wall, pull the plastic tight and repeat steps 1 and 2
4. Pull the plastic tight and attach it with spring wire along the hip braces one side at
a time. (*See Note Below)
5. Attach to end wall hoops from the hip brace to the baseboard.
6. Pull tight and attach plastic with the spring wire along the baseboards of the hoop
house.
7. Cut the plastic 3-4 inches away from the lock channel on both endwalls.
~For areas with severe winters or hurricanes: If you will be removing the plastic
during the winter, leave 6-12 inches of plastic all the way around to make
reinstallation easier.~
8. Cut the plastic all the way along the baseboard 3-4 inches from the lock channel.
(For roll up sides, leave at least 6" past the baseboard.)
* Note: If you have rollup sides you will not do steps 6 and 7, but will need to cut
the plastic as described in steps 8 and 9.
Scan QR for info on
Installing Plastic or visit
https://youtu.be/qxApDmKXYyo
Installing End Wall Plastic
Once the top/ long sides are covered, and you have cut the excess plastic off of the
hoop at the lock channel you can begin endwall installation.
Need Help? contact@bootstrapfarmer.com
Page 29
www.bootstrapfarmer.com