Table of Contents
Advertisement
5. Add an Upper 2x4:
● Cut another 2x4 to sit directly above the header, forming an 'L' shape, and
flush with the outer edge of the door frame.
● This reinforces the header. Secure it in place with screws.
Installing Side Posts
1. Measure and Cut Side Posts: For additional support and to attach wiggle wire
lock channels later, install vertical posts on each side of the door frame.
● Place the bottom of these posts on the ground and mark the top just
underneath the hoop.
● Cut the posts to size and secure them alongside the door frame with
2.5-inch wood screws.
Building the Door
1. Frame the Door: Use two 1"x 4" boards to construct the door frame. Make the
door width ¾" narrower and length ⅞" shorter than the door opening to allow for
expansion.
2. Add Support and Materials:
● For door stability, place a plastic roofing panel, chicken wire, or a similar
supportive material between the two 1"x4" boards.
● Include a 1"x4" board in the middle of the door for additional stability.
3. Install the Door:
● Use zinc-plated hinges for attaching the door, ensuring even spacing
between the door and frame for smooth operation.
● Once installed, surround the door frame with a lock channel to secure the
door's cover material.
4. Finish with Lock Channel and Wiggle Wire: Attach the lock channel and
wiggle wire around the door to secure the plastic or other covering materials,
based on your specific needs.
Need Help? contact@bootstrapfarmer.com
Page 27
www.bootstrapfarmer.com
Advertisement
Table of Contents
