Table of Contents
Advertisement
Installation
1. Roll the end of the plastic onto the EMT pipe you made earlier. Make sure you
roll it under the pipe like in the diagram so that the rolled plastic does not collect
rainwater.
2. Install eye bolts on every other hoop alternating between the hip boards and
baseboards to create a zig-zag pattern. These will serve as attachment points for
the strapping material.
3. Install the snap clamps every 18" or so with the ends a little closer together. The
first time you slowly roll it up it will likely not roll up even. As you roll it up and
down you will pull down on higher parts to tighten up your roll.
4. Roll it up and down a few times during this process and it will work out the loose
sections and become straighter.
5. String paracord or strapping through the eyebolts to keep the side from bowling
in the wind when partially rolled up.
6. Repeat the process on the opposite side.
Need Help? contact@bootstrapfarmer.com
Page 34
www.bootstrapfarmer.com
Advertisement
Table of Contents
