Ridge Poles; End Wall Cross Connector - Bootstrap Farmer DIY High Tunnel Plans Instructions Manual

Ridge Poles

End Wall Cross Connector

The end wall connector is manufactured in the OPEN position for easier installation over
the hoops. End wall cross connectors help to keep the ridgepole from extending past
the end hoops and poking the plastic end walls. We recommend adding a #8
self-tapping screw to all tension bands and end wall cross connectors - but not the
saddle-type cross connectors on the interior hoops.
Scan QR for info on End Wall Cross
Connectors or visit
https://youtu.be/cAYCGLnQqIU?si=5RSC_A_OqWy-5x2l
Note: Since each hoop will connect to the first end wall, it should be carefully made
plumb and held that way as you make the connections. You can do this easily using
stakes and rope. Wrap a rope up and around the hoop. Using a magnetic level, stake
the rope securely on either side of the hoop with the hoop directly perpendicular to the
ground. If you need to, move the stakes slightly left or right to secure the hoop in the
proper position.
Tools
● Ladder
● Clamps
● Drill with 3/16" drill bit
● Hammer (16 oz)
● Slip joint pliers for installation.
Need Help? contact@bootstrapfarmer.com
Scan QR for info on Stabilizing Your End
https://youtu.be/eXq7C5LAeVQ?t=300
Parts
● End Wall Cross Connectors
● Ridge Pole 1 ⅜ top rail
Page 17
www.bootstrapfarmer.com