Table of Contents
Advertisement
Cross Connectors and Ridge Poles
Ridge poles and cross connectors work together to connect and stabilize the hoops.
Optional purlins and additional cross connectors further stabilize the structure and are
installed the same way outlined below.
Tools
● Rope/ Stakes
● Drill w/ ¼" bit
● Step ladder
● Saw
● Ratchet & Sockets
● Tape measure
● Wrench
Install Ridge Pole and Connectors
1.
Loosely place a cross connector on the top of each of the rest of the hoops
except the final hoop.
2.
Starting at one end wall, carefully ensure that the end wall is still plumb.
3.
Connect the ridge poles together with #8 self-tap through from the bottom or on
the side at the swaged connection. Insert the pole into the end wall cross
connector and the next hoop cross connector. Continue adding ridge poles until
the other end wall is reached.
4.
Center the loose assembly on the very top and center of the hoop, double-check
the plumb of the end wall, and tighten the bolt on the connector using a ratchet.
5.
Measure 4' on center from 1st tightened connector to the next connector and
secure at that point.
6.
Repeat this process for each hoop as you make final plumb adjustments while
keeping cross connectors 4' apart.
Need Help? contact@bootstrapfarmer.com
Parts (PER 20FT)
● ¼ x 2" bolt galv. (15)
● ¼ nut galv. (15)
● ¼ split lock washer galv. (15)
● ¼ flat washer galv.(30)
●
10' x 1⅜" top rail
● Cross Connector 1.375"
● End Wall Cross Connector 1.375"
● #10 self-tap screw
Page 19
www.bootstrapfarmer.com
Advertisement
Table of Contents
