Auto Altitude Calibration
Enabling auto altitude calibration with CASIO
WATCHES will cause altitude values to be
acquired by CASIO WATCHES, which will be
used to automatically correct the watch's
altitude reading.
Important!
Use CASIO WATCHES to enable or
●
disable auto altitude calibration. It
cannot be enabled or disabled on the
watch.
Note
If an altitude value acquired by CASIO
●
WATCHES satisfies accuracy
conditions, the watch will automatically
correct is altitude reading.
Auto altitude calibration is performed
●
at the same time as auto time
adjustment.
Auto altitude calibration is not
●
performed for 12 hours after the time
setting is adjusted manually.
Operation Guide 5601
Recording Waypoints and
Their Altitudes (Route Log)
Route Log uses CASIO WATCHES GPS to
record the waypoints of your routes. At the
same time, the watch takes altitude readings
every two minutes and stores them in memory,
and automatically transfers altitude data to
CASIO WATCHES every hour.
1. Y
Tap the "CASIO WATCHES" icon.
2. X
Enter the Timekeeping Mode or
Altimeter Mode.
Navigating Between Modes
l
3. X
Hold down (A) for at least five seconds
until [LOG] starts to flash. Release the
button when the second hand moves to
[R].
When a connection is established
between the watch and phone, [LOG] will
change to [LOG ON], and the second
hand will move from [R] to [C].
This indicates that Route Log is
●
enabled.
Trying to connect
To disable Route Log, hold down (A)
●
again for at least five seconds.
Note
[LOG] is displayed while Route Log is
●
enabled.
Route Log becomes disabled
●
automatically 12 hours after it is
enabled.
Route Log remains enabled even if you
●
change to another mode.
Data Transfer
●
After Route Log is enabled, data transfer
starts when the number of altitude records in
watch memory reaches 30.
Auto data transfer is performed during the
●
normal state of each mode.
The display cycles as shown below as data is
being transferred.
The second hand will point to [R].
●
If data transfer fails for some reason, the
●
watch will return to the previous screen with
[LOG] flashing.
Connection
successful
Note
If auto transfer fails for some reason,
●
the watch will keep trying up to five
times at 10-minute intervals. Or data is
transferred when a CASIO WATCHES
connection is established.
The watch has enough memory to hold
●
up to 60 altitude records. Recording
data when there are already 60
records in memory will automatically
delete the oldest record to make room
for the new one.
13