Mode Customization - Casio 5601 Operation Manual

Triggering Immediate Time Adjustment
●
The watch's time setting will be adjusted
automatically whenever you establish a
connection between the watch and a phone.
Whenever you want to trigger immediate time
adjustment, perform the procedure below to
connect with a phone.
1.
Move the phone close to (within one meter
of) the watch.
2. X
Press (B).
[TIME] flashes to indicate that the watch
has started the connection operation.
When a connection is established
between the watch and phone, [OK] will
appear, time information will be acquired,
and then the watch's time setting will be
adjusted.
Trying to connect
Note
You can perform the above operation
●
for time adjustment from any watch
mode.
The connection is terminated
●
automatically after time adjustment is
complete.
If time adjustment fails for some
●
reason, [ERR] will appear.
Operation Guide 5601

Mode Customization

You can use CASIO WATCHES to customize
modes by rearranging them on the screen,
and by deleting or adding modes.
Important!
You cannot perform mode
●
customization operations on the
watch. Use CASIO WATCHES to
configure settings.
The modes below can be rearranged or
deleted.
Barometer Mode
●
Thermometer Mode
●
After time
Altitude Record Recall Mode
●
adjustment
Sunrise/Sunset Mode
●
Stopwatch Mode
●
Timer Mode
●
Alarm Mode
●
World Time Mode
●
1. Y
Tap the "CASIO WATCHES" icon.
2. X
Hold down (B) for at least two seconds
until the second hand points to [R] twice.
When a connection is established
between the watch and phone, [APP] will
change to [OK], and the second hand will
move from [R] to [C].
Trying to connect
3. Y
Perform the operations shown on the
phone screen to configure mode settings.
Note
Increasing or decreasing the number
●
of modes may change mode functions
and/or settings.
Even if you remove the Barometer
●
Mode, you can still display the
barometric pressure graph on the
Timekeeping Mode screen.
Even if you remove the Sunrise/Sunset
●
Mode, you can still display sunrise and
sunset times on the Timekeeping
Mode screen.
To initialize Mode Customization
●
Important!
Initializing Mode Customization also
●
initializes watch settings.
Note
Mode Customization cannot be
●
initialized while Route Log is enabled.
1. X
Enter the Timekeeping Mode.
Navigating Between Modes
l
2. X
Hold down (D) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
Connection
successful
the display.
3. X
Press (D).
This causes the seconds to flash.
4. X
Hold down (C) for at least five seconds.
Release it when [RESET] stops flashing.
This initializes Mode Customization.
5. X
Press (D) to exit the setting screen.
Home City
Seconds
10