Table of Contents
Advertisement
3. X
Hold down (C) for at least two seconds.
Release the button when [INDICATE]
starts to flash, and the second hand points
to
.
When a location information receive
operation is successful while the watch is
connected with a phone, [INDICATE] will
change to [OK].
After two seconds the distance from your
current location to the recorded location
will appear on the display, and the second
hand will indicate the bearing to the
destination.
After two seconds
Bearing to destination
Bearing to destination
North indication
North indication
*1
*2
Distance from your current location
*1
[
] will flash on the display when the
second hand is within the range between
55 seconds to 05 seconds (indicating that
you are within 30 degrees of the bearing
to the destination).
*2
[G] is shown on the display when you are
within 80 meters of the destination. [G] will
disappear from the display if you move to
a distance of 161 meters or more from the
destination.
4. X
Check the display distance and the
bearing to your destination on the display.
Watch Operation Guide 5713
Note
Location Indicator remains enabled for
●
three minutes.
The watch connects with the phone
●
and acquires location information
every 10 seconds or each time (C) is
pressed, and uses the acquired
information to refresh the distance and
the bearing up to the point stored in
Location Memory.
Location Indicator will become
●
disabled automatically about three
minutes after it is enabled. You can
also disable it manually by pressing
any button besides (C) or (E).
Second
Pressing (C) or (E) while Location
hand
●
Indicator is enabled causes it to remain
enabled for three minutes after the
button is pressed.
Pressing (C) to update data causes [
●
TRY] to appear on the display and
remain displayed until data updating is
complete.
[
FAIL] will appear on the display in
●
the cases below.
When it has been 30 seconds or
ー
more since the last update and
location information acquisition fails
When it has been 60 seconds or
ー
more since the last update
When data update fails after you
ー
press (C)
The display range for the distance to a
●
destination is 0 to 99,999 meters (0 to
327,995 feet). [
for the distance to the destination when
it is outside the display range.
[ERR] will appear on the display if
●
connection fails for some reason.
The message [NO-DATA] will appear
●
when there is no data in Location
Memory.
[FAILED]
●
sequence if the first location
information acquisition fails.
[
] or [G] will flash on the display if the
●
watch detects abnormal magnetism
while Location Indicator is in use.
[
ERR] will appear on the display if a
●
direction sensor error occurs while
Location Indicator is in use.
-----] will be shown
[POSITION] will appear in
n
Auto Altitude Calibration
Enabling auto altitude calibration with CASIO
WATCHES will cause altitude values to be
acquired by CASIO WATCHES, which will be
used to automatically correct the watch's
altitude reading.
Important!
Use CASIO WATCHES to enable or
●
disable auto altitude calibration. It
cannot be enabled or disabled on the
watch.
Note
If an altitude value acquired by CASIO
●
WATCHES satisfies accuracy
conditions, the watch will automatically
correct is altitude reading.
Auto altitude calibration is performed
●
at the same time as auto time
adjustment.
Auto altitude calibration is not
●
performed for 12 hours after the time
setting is adjusted manually.
18
Advertisement
Table of Contents
