Setting Up The Board - ST X-STM32MP-NFC08 User Manual

3.3

Setting up the board

Perform the following steps to set up the board:
• Check that the jumper on the J1 connector is connected. This jumper enables the write operation for
EEPROM
• Connect the
• Ensure that pin 1 of the
Pin 1 can be identified as a rectangular footprint pad on both boards
Note: Boards can be damaged if not connected properly
Note: LED D7 (A P2P) on the
DK2 boards. To use this LED below solder bridge modifications are required on the
board:
Close solder bridge: SB16
Open solder bridge: SB01
Note: Some of the audio functionality of the
If you do not intend to do any modification on the
disabled in software, please refer to the
• Power the
• Flash the OpenSTLinux Starter package image to a SD card and insert in the
• X-STM32MP-NFC08
• Refer to the
UM3260 - Rev 1
X-STM32MP-NFC08 to the
X-STM32MP-NFC08
X-STM32MP-NFC08
STM32MP157F-DK2
STM32MP157F-DK2 using the USB Type-C® cable
board is ready for use
X-LINUX-NFC1 expansion software package to set up the software for the board
Getting started with the X-STM32MP-NFC08 expansion board
STM32MP157F-DK2 40 pin GPIO connector
board matches with pin 1 of the
board is shared with audio codec on the
board may get affected after this modification.
STM32MP157F-DK2
X-LINUX-NFC1 documentation for more details.
UM3260
STM32MP157F-DK2 board.
STM32MP157F-
STM32MP157F-DK2
board the NFC LEDs must be
STM32MP157F-DK2
page 10/27
board