Some obstacles are resistant to a collision, for example,
trees or bushes that are more than 15 cm / 5.9 in. in
height. The product will collide with the obstacle and
then select a new direction.
•
Put the boundary wire to and around the obstacle
to make an island.
•
Put the 2 sections of boundary wire to and from the
island close together. This will make the product
run across the wire.
•
Put the 2 sections of boundary wire in the same
stake.
0 cm / 0"
3.4.3.4 To make a secondary area
Make a secondary area (B) if the work area has 2 areas
that are not connected with a passage. The work area
with the charging station is the main area (A).
Note:
The product must be manually moved between
the main area and the secondary area.
B
A
•
Put the boundary wire around the secondary area
(B) to make an island. Refer to
on page 14 .
2369 - 001 - 05.02.2024
To make an island
Note:
The boundary wire must be put as 1 loop
around all of the work area (A + B).
Note:
When the product cuts grass in the
secondary area, the
be selected. Refer to
25 .
3.4.4 To examine where to put the guide
wire
•
Put the guide wire in a line at a minimum of 2 m /
6.5 ft. in front of the charging station.
•
Make as much free area as possible to the left of
the guide wire when facing the charging station.
•
Put the guide wire minimum 30 cm / 12 in. from the
boundary wire.
•
Do not make sharp bends when you install the
guide wire.
135º
•
If the work area has a slope, put the guide wire
diagonally across the slope.
3.4.5 Work area examples
•
If the charging station is put in a small area (A),
make sure that the distance to the boundary wire
is at a minimum 3 m / 10 ft. in front of the charging
station.
•
If the work area has a passage (B) with no
guide wire installed, the recommended minimum
distance between the boundary wires is 2 m / 6.5
ft. With a guide wire installed through the passage,
the recommended minimum distance between the
boundary wires is 60 cm / 24 in.
•
If the work area has areas which are connected by
a narrow passage (B), you can set the product to
first follow and then leave the guide wire after a
certain distance (C). The settings can be changed
Lawn coverage on page 22 .
in
•
Use the GPS Assisted Navigation that helps the
product select the most optimal operation. Refer to
GPS assisted navigation on page 22 .
•
If the work area includes a secondary area (D),
To make a secondary area on page 15 .
refer to
Put the product in the secondary area and select
Secondary area mode .
Secondary area mode must
Secondary area on page
90º
135º
Installation with wire - 15