Table of Contents
Advertisement
Message
No loop signal
Outside work area
Upside down
Mower tilted
32 - Troubleshooting
Cause
There is no power in the charging station.
The LED indicator on the charging station is
not on.
The boundary wire is damaged or not instal-
led correctly.
ECO mode is enabled and the loop signal is
disabled when the product is started in the
work area.
The boundary wire is crossed on its way to
and from an island.
The product does not find the loop signal
from the charging station.
Disturbances from metal objects (fences, re-
inforcement steel) or buried cables close by.
The product is too far from the boundary
wire.
The boundary wire connections to the charg-
ing station are crossed.
The boundary wire is too close to the edge of
the work area.
The work area is too steep by the boundary
wire.
The boundary wire around an island is not
installed correctly. The boundary wires are
crossed.
Disturbances from metal objects (fences, re-
inforcement steel) or buried cables close by.
The product cannot find the correct loop sig-
nal because of interference with a loop signal
from a different product installation nearby.
The product is leaning too much or has
turned over.
The product tilts too much.
Action
Examine if the power supply unit or the low-
voltage cable is damaged or not installed
correctly to the power outlet or the charging
station. Examine if there is a power failure or
if a residual-current device is enabled.
Make sure that the boundary wire is connec-
ted correctly to the charging station. Examine
all splices on the boundary wire. Examine if
there is a break in the boundary wire and
repair if necessary. Refer to
boundary wire on page 17 .
Put the product in the charging station and
start the product. To start the product man-
ually in the work area, push the STOP but-
ton before you remove the product from the
charging station.
Make sure that the boundary wire is put
down correctly. Refer to
dary wire on page 17 .
Put the product in the charging station and
generate a new loop signal. Refer to
ble the loop signal on page 21 .
Try to move the boundary wire and/or make
more islands in the work area to increase the
signal strength.
Redo the installation of the boundary wire so
that all parts of the work area is maximum 35
m / 115 ft. from the boundary wire.
Make sure that the boundary wire is connec-
ted correctly to the charging station. Refer to
To install the boundary wire on page 17 .
Make sure that the boundary wire is put
down correctly. Refer to
dary wire on page 17 .
Try to move the boundary wire and/or make
more islands in the work area to increase the
signal strength.
Put the product in the charging station and
generate a new loop signal. Refer to
ble the loop signal on page 21 .
Turn the product the right way up.
Move the product to a level area.
2369 - 001 - 05.02.2024
To install the
To install the boun-
To ena-
To install the boun-
To ena-
Advertisement
Table of Contents
