Programming; Programming Track Numbers; Clearing A Program; Changing A Program - Philips CDR800 - annexe 2 Manual

xp CDR800/17 eng./dr.5 09-02-2001 12:11

Programming

Programming track numbers

– A program can be composed of tracks in both changer
and recorder deck.
– Any track can be stored more than once with a
maximum of 99 tracks.
– If you exceed the maximum of 99 tracks the display
shows PROGRAM FULL.
1 Load the desired disc(s) in the disc tray(s).
2 Select the first required disc by pressing CD 1, CD 2, CD 3,
or CDR.
3 Press PROGRAM.
starts blinking and PROGRAM is displayed.
PROGRAM
Rotate the ¡ EASY JOG ™ control to select the required
4
tracknumbers on the selected disc and store each track by
pressing YES.
If you wish to store all tracks of the selected disc, rotate the
0
¡ EASY JOG ™ control to select ALL and press YES to
store the complete disc in the memory.
The number of programmed tracks (
the total program time are displayed.
5 Select and store all required CD's and/or tracks in the same
way.
7 Press PROGRAM to end programming.
stays shown and the program is currently
PROGRAM
available.
18
Pagina 18

Changing a program

If necessary press STOP 9.
1
2 Press PROGRAM to enter Program mode.
Erasing tracks
Select the tracknumbers you wish to erase with 5 or 6
3
and erase each number by pressing NO.
Adding tracks
Rotate the ¡ EASY JOG ™ control to select the
3
tracknumbers you wish to add to the program and store
each track by pressing YES.
4 Press PROGRAM to end programming.

Clearing a program

If necessary press STOP 9.
1
2 Press NO.
3 Press YES to clear the program.
), PROG and
STEP

Making a program for recording

If the program is used for recording only tracks from discs
in the changer should be programmed. Also see chapter
"Recording a program".
CLEARED is displayed briefly.
The next programmed track number will move up to this
position and is displayed together with the step number
and the total program time.
The number of programmed tracks (
the total program time are displayed.
stays shown and the program is currently
PROGRAM
available.
CLEAR PROG ? is displayed.
PROG CLEARED will be displayed and
off.
), PROG and
STEP
goes
PROGRAM