Program; Programming Track Numbers; Erasing A Track From The Program; Clearing The Program The Program - Philips CDR785/01C User Manual

Programming track numbers

ON/O FF
STOP
PLAY /PAU SE
OPEN /CLOS E
CD TEX T EDIT ING
CDR
W
AUX
You can select tracks and store them either in the CD changer,
or CD recorder memory. If you use the program for playback
you can choose one of the two memories, else if you like to
specify tracks for recording, use the CD changer memory only!
You can store any track more than once.
1 Load the desired disc(s) in the disc tray(s).
2 Press either CD 1, CD 2, CD 3, or CDR to select the disc.
3 Press PROG(ram).
starts blinking and PROGRAM is displayed.
PROG
4 Rotate ¡ JOG CONTROL ™ (press the numerical keys on
the remote control; for 2-digit numbers, press the keys in
rapid succession) to select the required track numbers and
store each track by pressing YES.
The number of programmed tracks (
total program time are displayed.
TEXT TOTAL
STEP
1 2 3 4 5 6 7
CD RW
CD changer only
• If you wish to program a complete CD from the CD Changer
rotate ¡ JOG CONTROL ™ to select CD1 (or 2, 3) ALL
and press YES.
All tracks of CD 1 (or 2, 3) will be programmed.
STEP TEXT TOTAL TRACK TIME
1 2 3 4 5 6 7
CD RW
5 Press PROG(ram) to end programming.
stays shown and the program is currently available.
PROG
Note: If the maximum number of programmable tracks is
reached, the display shows PROGRAM FULL.
REPE AT
CD TEXT
CD 1
SHUF FLE
DISP LAY
CD 2
CD-C HANG E
CD 3
RECOR D
REC LEVEL BALA NCE
TEXT
PROG
TRAC K EDIT
CD CD
JOG CONT ROL
COMP ILE CD
REC TYPE NO
YES
ERASE
FINALIZ E
), PROG and the
STEP
TRACK TIME TOTAL REM REC TRACK TIME
8 9 10 11 12 13 14 15 16 17 18 19 20 +
COMPILE CD TRACK PROG
DIGITAL
CD RW
OPTICAL
SHUFFLE REPEAT ALL EDIT
ANALOG
RECORD IN PROGRESS FINALIZE ALC
TOTAL REM REC TRACK TIME
8 9 10 11 12 13 14 15 16 17 18 19 20 +
COMPILE CD TRACK PROG
DIGITAL
CD RW
OPTICAL
SHUFFLE REPEAT ALL EDIT
ANALOG
RECORD IN PROGRESS FINALIZE ALC

Erasing a track from the program

1 If necessary press STOP 9.
2 Press either CD 1, CD 2, CD 3, or CDR to select the desired
memory.
R
W
3 Press PROG(ram), followed by 5 or 6 to move through
the program steps.
The track number at the selected step and the total
program time are displayed.
4 Press NO to remove the track from the program.
CLEARED is displayed briefly.
The next programmed track number will move up to this
position and is displayed together with the step number
and the remaining total program time.
Clearing the program
1 If necessary press STOP 9.
2 Press NO.
CLEAR PROG ? is displayed.
3 Press YES to clear the program.
PROG CLEARED will be displayed and
Note: If you open the CD recorder or the CD changer tray the
respective program will be cleared.

Making a program for recording

See 'High speed recording and automatic finalizing (optional)
of the current program' under chapter 'Internal recording'.

PROGRAM

goes off.
PROG
21