Troubleshooting - Philips CDR800 - annexe 2 Manual

xp CDR800/17 eng./dr.5 09-02-2001 12:11
Problem
No power
No sound
Amplifier sound is distorted
Play will not start
Remote control does not work
Will not record
Recording is distorted
Recorded tracks do not start or stop
at the correct time or tracks have been
merged together
20 second pause between recordings
Recorded disc does not play
in other standard CD player
Pagina 27
WARNING
Under no circumstances should you try to repair the set yourself as this
will invalidate the guarantee.
Do not open the set as there is a risk of electric shock.
If a fault occurs, first check the points listed, before taking the set for
repair. If you are unable to solve a problem by following these hints,
consult your dealer or service centre.
Laser safety
This unit employs a laser. Only a qualified service person should remove
the cover or attempt to service this device, due to possible eye injury.
Solution:
– ensure that the ON/OFF button is on: the set is in standby mode, press any
key to activate it
– ensure that the mains cable is plugged in correctly
– switch the set OFF and then immediately back ON
– check the audio connections
– try using a different source on the amplifier
– check that the analog output of the set is not connected to the amplifier
Phono input
– ensure that the label of the CD is facing up
– clean the disc
– check that the disc is not defective by trying another disc
– first select the right source on the remote control
– point the remote control directly at the set
– check the batteries and replace if necessary
– clean the disc
– check if CDR(W) is an unfinalized disc
– check that the disc is recordable and replace if necessary
– the disc is not an AUDIO disc (WRONG DISC)
– wrong input source chosen. Input label flashing (CHECK INPUT)
– make sure the recording level is correct
– try another auto track setting
– check if there are at least 2.7 seconds silence in between the tracks (analog
recording only)
– insert track increments manually with the remote control
– see "Recording with automatic start".
– finalize the CDR(W)
– insert the CDRW in a CDRW compatible player

Troubleshooting

27