Sony DVCAM DSR-1800 Operating Instructions Manual page 63

VIDEO CONTROL [Video]: Settings related to video control | Description of settings
WIDE MODE [>Wide mode]: Determine whether to retain *AUTO [>> Auto]: When video being recorded or played back
wide-screen aspect ratio information accompanying video is accompanied by wide-screen aspect ratio information,
being recorded or played back. retain the information.
OFF [>> OFF]: Ignore wide-screen aspect ratio information.
ON [>> ON]: Whenever recording or playing back video, retain
wide-screen aspect ratio information.
*OFF [>> OFF]: Do not enable.
ON [>> ON]: Enable.
When playing back a composite signal, set this to ON.
*REMOTE [>>>REMOTE]: Use the optional UVR-60/60P or
BVR-50/50P Remote Control Unit to remote control the
internal digital video processor.
MENU [>>> MENU]: Use the setup menu to change the
settings for the internal digital video processor.
*U/V (COMPOSITE) [>>> Cmpst]: Select this setting when
observing the composite video output level using a
composite vectorscope.
PB/PR (COMPONENT) [>>> Cmpnt]: Select this setting
when observing the component video output level using a
component vectorscope.
ESR MODE [>ESR mode]: Select whether to enable the edge
subcarrier reducer (ESR). :
PROCESS CONTROL [>Proc
ctrl]
CONTROL DEV [>>Ctrl
dev]: Select the
method of controlling
the internal digital
video processor.
C PHASE MODE [>>C
Phas MD]: Select the
phase rotation mode
for chroma phase
control.
The effect of this setting
applies to the output levels
of ail of the composite
video, S video, SDI and
component video signals.
ADJ RANGE [>>Adj
range]: Select the
variable range of the
VIDEO and CHROMA
gains.
VIDEO GAIN [>>V gain]:
Adjust the video output
level.
CHROMA GAIN [>>C
gain]: Adjust the
chroma output level.
CHROMA PHASE [>>C OOH to FFH
phase]: Adjust the Factory default setting: 80H
chroma phase.
(For DSR-1800 only) OOH to 3FFH
SETUP LEVEL [>>Setup | Factory default setting: 200H
lev]: Adjust the black
setup level.
(For DSR-1800P only) OOH to 3FFH
BLACK LEVEL [>>Black | Factory default setting: 200H
lev]: Adjust the black
level.
LINE 335 [>>Line 335]:
Switch blanking on or
off for the 335th line of
the input video signal.
AUDIO CONTROL [Audio]: Settings related to audio Description of settings
control
REC MODE [>REC mode]: Select the audio recording mode. | *2CHANNEL (48kHz) [>> 2 ch]: 2-channel, 48-kHz mode
4CHANNEL (32kHz) [>> 4 ch]: 4-channel, 32-kHz mode
*-3 to +3 (dB) [>>> —3/+3]: -3 dB to +3 dB
WIDE [>>> wide]: --o to +3 dB
OOH to 3FFH
Factory default setting: 200H
00H to 3FFH
Factory default setting: 200H
(For DSR-1800P only)
INPUT BLANK [>Input bink]
BLANK [>>> blank]: Blank.
THROUGH [>>> through]: Do not blank.
Menu Contents
nT
s6Buines nue, yp saideyup
63