Sony DVCAM DSR-1800 Operating Instructions Manual page 26

1 Power on the video monitor, then set its input switches according to the
signals input from this unit.
2 Set up the player to play back a tape.
For details, refer to the operating instructions for the player.
3 Power on this unit by pressing on the | side of the POWER switch.
4 When the REMOTE button is not lit (the external editing control unit is nc
used), use the COUNTER SEL button to select the type of time data to be
used.
Each press of this button cycles through three options: COUNTER (CNT
value), TC (time code), and U-BIT (user bit data). The time data type
indicator for each option lights as it is selected.
nnn
Selected time data Time data type indicator
Count value of the time counter COUNTER
Time code
User bit data
When the REMOTE button is lit, selection of the time data type is carriec
out at the editing control unit.
5 Select the formats of video and audio input signal to be recorded.
Use the buttons in the INPUT SELECT section to select the desired signa
formats. Each selection is shown by a lit indicator in the input selection/
audio mode display section.
Corresponding button | Lit indicator in the
in the INPUT SELECT | input selection/audio
section mode display section
Composite signal VIDEO IN COMPOSITE in VIDEO
(VIDEO IN) group
Separated Y/C signal VIDEO IN
(S VIDEO IN)
S VIDEO in VIDEO
group
Component signal VIDEO IN
(COMPONENT VIDEO
SDI signal (SDI IN) VIDEO IN
Y-R, B in VIDEO group
SDTI (QSDI) signal SDTI/i.LINK
(SDTI (QSDI) IN)
i.LINK-compatible digital | SDTI/i.LINK
video signal in DV format
(i.DV IN/OUT)
Internal test video signal | VIDEO IN SG in VIDEO group
a) The indicator does not light even if you press the corresponding button in the INPUT SELEC
section unless the required optional digital input/output board (DSBK-1801/1802/1803) is
installed.
yoegAeig pue Buipiovey =z seydeyo
Video input signal
(input connector)
2
SDI) in VIDEO group
SDTI®: both SDTI videc
and audio input
signals are
recorded.
V:SDTI): only SDTI
video input signal is
recorded. ,
i.LINK ®)
26 Recording