Sony DVCAM DSR-1800 Operating Instructions Manual page 17

[1] Analog video signal input/output section
ANALOG VIDEO
| @ S VIDEO IN connector
VIDEO IN connectors
@ VIDEO IN connectors (BNC type)
Input an analog composite video signal. This connector
block has a built-in automatic 75 Q termination switch.
When a signal is input to the left VIDEO IN connector
with no bridging (loop-through) connection made, the
connector is terminated with an impedance of 75 Q
automatically. To connect the signal input to the left
VIDEO IN connector also to other. equipment, use the right
VIDEO IN connector (marked "™). When the right
VIDEO IN connector is used, the built-in 75 Q termination
switch turns off automatically.
© S VIDEO IN connector (4-pin)
Input an S-video signal with separated Y (luminance) and
C (chroma: 3.58 MHz for DSR-1800 or 4.43 MHz for
DSR-1800P) components to this connector.
S VIDEO ie ndinicee aes IN REF. scan
iN R-Y ao WN
Rcierreensensnsennstineenccnannaiannessccennnncsassnnennes Nunccsaseneesa cere a a e r a
MEG On SEG
© VIDEO OUT 1 and 2 (SUPER)
connectors
REF. VIDEO IN/OUT connectors
© COMPONENT VIDEO IN Y/R—Y/B—Y connectors
TIME CODE
& TIME CODE IN/OUT connectors
@ COMPONENT VIDEO OUT Y/R-Y/B—Y connectors
@ S VIDEO OUT connector
© COMPONENT VIDEO IN Y/R-Y/B-Y connectors
(BNC type)
Input analog component video signals (Y/R-Y/B-Y) to
these connectors.
© REF. (reference) VIDEO IN/OUT connectors
(BNC type)
Input a reference video signal. The IN connector block has
a built-in automatic 75 Q termination switch. When a
signal is input to the left REF. VIDEO IN connector with
no bridging (loop-through) connection made, the
connector is terminated with an impedance of 75 Q
automatically. To connect the reference video signal input
to the left REF. VIDEO IN connector also to other
equipment, use the right REF. VIDEO IN connector
(marked "). When the right REF. VIDEO IN connector
Location and Function of Parts
malAsaa tL daideus TT
17