Formax OnSite FD 8304CC Operator's Manual

Features
Automatic Reverse Rotation
When too much paper is inserted, the cutter stops operating and
automatically rotates in reverse to discharge the jammed paper. The
shredder will beep. Reduce the amount of paper and resume shredding.
Door Switch
If the door is open, the shredder will not operate.
Automatic Stop
When the waste bin is full, the "FULL" LED will light and the cutter stops
operation. Open the door, remove the waste bin and empty. Replace
the waste bin, close the door, and press START to resume operation.
Automatic Power Shut-Off
If the shredder operates continuously for more than 30 minutes, the
power is automatically shut off.
Oiling the Cutting Blades
For peak performance, Formax recommends oiling the shredder blades after every 4
hours of operation. Use a cutting head lubricating oil like Formax part #8000-10.
To oil: Spread a small amount of shredder oil onto the cutters through the feed opening,
and allow the oil to sit for a few minutes to permeate the cutting blades, then press the
"REV" button and hold for five seconds. The "REV" LED indicator on control panel will
light. The shredder will operate in reverse for one minute, then the "AUTO" LED will light
indicating the shredder is ready for use.
Operator Maintenance
• Disconnect power by pulling power cord plug from wall outlet.
• To clean the exterior, wipe the surface with a soft cloth. If the surface is very dirty, use
a neutral detergent, then wipe again with a soft cloth.
CAUTION:
• Never put water directly on the surface of the shredder.
• Never clean the case with benzene or thinner, since it will cause discoloration.
• Do not dismantle the shredder. Contact your Formax Dealer for service.
FD 8304CC Shredder
3/2024
OPERATOR MANUAL