Installing A Rear Panel - PrimeVOLT PV 2KTL-S1/G2P User Manual

4.3

Installing a Rear Panel

Before installing the inverter, secure the rear panel to a wall.
Step 1 Move out the rear panel from the packing case.
Step 2 Determine the positions of rear panel to drill holes (as shown in Figure 4.9).
NOTICE
2K~3.6K PV Inverter Dimensions for
Single MPPT Route Input
Step 3 Level the hole positions using a level gauge, and mark the hole positions using a marker (as shown in
Figure 4.10).
Step 4 Drill holes using a hammer drill and install expansion bolts, as shown in Figure 4.11.
DANGER
For 4K-6K inverter, please choose one of the two-hole groups (①&④ or
②&③) to drill.
320
379.5
160
79
8
162.9
265
Figure 4.9 Determine the positions for drilling holes (unit: mm)
Figure 4.10 mark the hole positions using a marker
Before drilling the hole on the wall, ensure no damage on the electric wire
and/or water pipe inside the wall.
350
296
160
41
31
105
① ②
4K~6K PV Inverter Dimensions for
Dual MPPT Routes Input
Horizontally
16
4 Installation 4 Installation
69
8
31
③ ④
278