Table of Contents
Advertisement
Pair Sensors
Pair your sensors with the device beforehand. Rider 460 will scan nearby active paired sensors,
making switching between bikes and sensors easier and more convenient.
1. Long press
to enter the menu.
2. Select Menu > Settings > Sensors
Add New Sensors
1. Select Add New to add new sensors.
2. Choose any type of sensor that you would like to pair with.
3. To pair sensors with your device, please have Bryton Smart
Sensors installed first, then wear a heart rate monitor or rotate
the crank and wheel a few times to wake Bryton Smart Sensors up.
4. For Bike Radars, E-bikes, and Ess/Di2, please turn the power on
before starting pairing.
5. Let the device detect sensors automatically or select to enter a
sensor ID manually.
6. Pick a detected sensor you would like to pair with then select to
save.
Deactivated sensors
1. Select the sensor you would like to deactivate.
2. Press
to turn off the status then sensors will be deactivated.
Activate Paired Sensors
1. Select the sensor you would like to activate.
2. Press
to turn on sensor status then sensors will be
connected automatically.
3. If the sensor fails to be connected or you want to switch to this
sensor, select to reconnect it with your device.
Remove sensors
1. Choose the sensor you would like to remove.
2. Select Remove to remove the sensor.
Switch Sensors
1. If another paired sensor is detected, the device will ask you if
you want to switch to another sensor.
2. Press
to switch the sensor.
NOTE:
•If you select X in the sensor found notification, the detected sensor will not be detected and
connected until the device reboot. You can toggle its status off/on to activate it again.
•Sensors only need to be switched if they are in the same type and both are already added in the
list.
2 5
Advertisement
Table of Contents
